Materials such as drywall and metal profiles have a small cost and easy to work with them, so you can create really grandiose structures from them.
The most popular product made of drywall are niches. You can use them anywhere. For example, you can build a niche for a TV, for a collection of figurines, for books and much more. You can find out more interesting things on Фугу казино официальный сайт.
DIY drywall niche
In almost every design of drywall there is a metal frame, which is a very important element, the appearance of the finished product depends on it. It is necessary to collect the frame from load -bearing profiles and guide profiles fastened with self -tapping screws.
The construction of the niche should start by the construction of its shape on the floor, ceiling and wall, this must be done using guide profiles.
Also an integral part of the niche from drywall are shelves. They can be made in several ways, namely:
one. Can be assembled from profiles, and then sheathed with gypsum;
2. Make a glass.
During the skin of the niche with drywall, you need to pay attention to the following:
one. The fitting of drywall sheets should be of high quality. Especially you need to pay attention to internal corner compounds.
2. Thin drywall intended for ceilings bends well, does not require preliminary preparation.
3. Gypsum should not be wetted because it becomes very brittle.
Any niche needs putty. You should start with the fact that with the help of glue and Serpyanka you need to close the seams between the sheets. Then you need to install perforated corners to attach them, you need to use putty or glue. Finish putty can be purchased here/Syhie-Smesi/Finishnaya-Shpaklevka/Bergauf/.
When everything dries, you can proceed directly to the putty niche. All flaws that were formed when putting putty can be fixed using a grinding machine.
DIY Hypsum Carton
With the help of drywall, you can align any walls in the house, including wooden. Before starting the skin, the walls need to be prepared and installed the frame.
Measure the area for calculating the required material – drywall and insulation. Build a steam -deck layer on the walls with a construction stapler, it will protect drywall and moisture insulation and insulation.
Install the frame. Mount the frame from a special profile or beam width of centimeters. If you use mineral wool, the beam can be any. Collect the frame in a vertical plane by placing the bars, fastening the walls from then from above and below, all other strips should be at the same level with them. Distance between bars do 0 centimeters. The vertical of the design periodically check the construction level.
DIY gypsum plasters with gypsum plasters after the installation of the crate involves laying the insulation. Net the rolled insulation to the walls with a stapler, and insert the leaf between the strips. Use polystyrene or polystyrene foam.
It is easy to cut drywall with a special knife. Cut along the line and break the sheet on this section. After that, finally cut the cardboard.
Fix the sheets of the desired size to the frame with self -tapping screws (25mm) after 30 centimeters. Make sure that the hats are recessed into the GCL, in this case, putty will be better, the finished wall will be even and attractive. Between the sheets of the material, the presence of cracks is permissible, which can subsequently be embedded, but only if the gap is at the place of fit of the beam and hyposcarton. In other cases, the walls will be laid down poorly.
If all the technologies are observed, then the walls of the walls with gypsum plasters with your own hands in a wooden house are finished, it remains to carry out the finish finish.